Motor

From BitWizard Wiki
Jump to navigation Jump to search
The printable version is no longer supported and may have rendering errors. Please update your browser bookmarks and please use the default browser print function instead.
The SPI_motor PCB
The SPI_motor PCB

This is the documentation page for the SPI_motor board.

Overview

This board enables you to control two regular (brushed) DC motors, or one stepper motor.

Assembly instructions

None: the board comes fully assembled.

Specifications

Possible Configurations

External resources

Datasheets

The 5A FETs The 15A FETs

Additional software

Related projects

Pinout

For the SPI connector see: SPI_connector_pinout.

The output connector is connected as follows:
(Looking at the business end of the connector, counting from left to right)

pin function
1 Output A1
2 Output A2
3 Output B1
4 Output B2
5 GND
6 Vin

Jumper

LEDs

The only LED is a power LED.

jumper settings

See solder jumpers on how to change the solder jumper.

By changing the solder jumper SJ1, you can make connector SPI1 (nearest to the board edge) into the ICSP programming connector for the ATmegaxx8 on the board.

Protocol

For the intro to the SPI and I2C protocols read: SPI versus I2C protocols

The board specific protocol can be found here: DIO_protocol

You should also read the General_SPI_protocol notes.
For arduino, a sample PDE is available, called ardemo_lcd.pde, also at BitWizard software download directory .

This is a demo to send things using SPI to the lcd board. The SPI routines there are applicable for the DIO, 3FETS and 7FETS boards as well.

The software

Default operation

Future hardware enhancements

Future software enhancements

TODO: write a library to make handling this board easy.

Changelog

1.0

  • Initial public release