Dio breakout

From BitWizard Wiki
Jump to navigation Jump to search
The printable version is no longer supported and may have rendering errors. Please update your browser bookmarks and please use the default browser print function instead.
The DIO breakout board
The DIO breakout board.

This is the documentation page for the DIO_breakout .

Overview

This board enables use screw terminals to connect wires to your SPI_DIO or I2C_DIO board.

Assembly instructions

None: the board comes fully assembled.


Related projects

DIO

Pinout

The connector at the bottom of the board is laid out as follows:

pin function
1 GND
2 IO0
3 IO1
4 IO2
5 IO3
6 IO4
7 IO5
8 IO6


the power-connector at the top of the board is laid out as follows:

pin function
1 GND
2 VCC
3 GND
4 VCC
5 GND
6 VCC
7 GND
8 VCC

The dataconnector in the middle of the board is compatible with the DIO board:

pin function
1 GND
2 VCC
3 IO0
4 IO1
5 IO2
6 IO3
7 d.n.c.
8 IO4
9 IO5
10 IO6

jumper settings

There are no jumpers.

configurations

You can chose to have your board equipped with a 10-pin female connector that allows your board to directly fit on top of the I2C-DIO board. This would conflict with the SPI connectors so don't chose this option for an SPI_DIO.

You can chose to have your board equipped with a male 10-pin connector that allows you to connect your board with the SPI_DIO or I2C DIO using a short 10pin IDC cable.

Future hardware enhancements

may 2013: This is vaporware: hardware will be available june 2013.

Future software enhancements

Changelog

1.0

  • Initial public release