Motor

From BitWizard Wiki
Jump to navigation Jump to search
The SPI_motor PCB
The SPI_motor PCB

This is the documentation page for the SPI_motor board.

Overview

This board enables you to control two regular (brushed) DC motors, or one stepper motor.

Assembly instructions

None: the board comes fully assembled.

Specifications

Possible Configurations

External resources

Datasheets

The 5A FETs The 15A FETs

Additional software

Related projects

Pinout

For the SPI connector see: SPI_connector_pinout.

The output connector is connected as follows:
(Looking at the business end of the connector, counting from left to right)

pin function
1 Output A1
2 Output A2
3 Output B1
4 Output B2
5 GND
6 Vin

Jumper

LEDs

The only LED is a power LED.

jumper settings

See solder jumpers on how to change the solder jumper.

By changing the solder jumper SJ1, you can make connector SPI1 (nearest to the board edge) into the ICSP programming connector for the ATmegaxx8 on the board.

Protocol

To make the motor PCB do things, you need to send things over the SPI bus to the PCB.

The general overview of the protocol is here.

The specific commands for the motor PCB are explained in Spi_motor_protocol.

For arduino, a sample PDE is available, called ardemo_lcd.pde, also at BitWizard software download directory .

This is a demo to send things using SPI to the lcd board. The SPI routines there are applicable for the motor board as well.

The software

Default operation

Future hardware enhancements

Future software enhancements

TODO: write a library to make handling this board easy.

Changelog

1.0

  • Initial public release