Difference between revisions of "Motor"

From BitWizard Wiki
Jump to navigation Jump to search
Line 13: Line 13:
== Specifications ==
== Specifications ==


Board size: 50mm x 50mm
Board size: 50mm x 50mm<br>
Maximum motor voltage: 24V
Maximum motor voltage: 24V<br>
Maximum motor current: 5A or 15A, depending on your version
Maximum motor current: 5A or 15A, depending on your version<br>


=== Possible Configurations ===
=== Possible Configurations ===

Revision as of 13:08, 18 May 2012

The SPI_motor PCB
The SPI_motor PCB

This is the documentation page for the SPI_motor board.

Overview

This board enables you to control the direction and speed of two regular (brushed) DC motors, or one stepper motor.

Assembly instructions

None: the board comes fully assembled.

Specifications

Board size: 50mm x 50mm
Maximum motor voltage: 24V
Maximum motor current: 5A or 15A, depending on your version

Possible Configurations

We ship two different versions of this device; a 5A version, and a 15A version. A sticker on the bottom of the board defines which of the two it is.

External resources

Datasheets

Additional software

Related projects

Pinout

For the SPI connector see: SPI_connector_pinout.

The output connector is connected as follows:
(Looking at the business end of the connector, counting from left to right)

pin function
1 Output A1
2 Output A2
3 Output B1
4 Output B2
5 GND
6 Vin

Jumper

The FET drivers need a 8V to 14V power supply. Plese refer to the following table for the correct jumper settings:

Motor voltage jumper setting
<8V No jumper, external 8V to 14V power source connected to pin 2
8V to 14V Jumper on pins 1 and 2
>14V Jumper on pins 2 and 3

LEDs

The only LED is a power LED.

jumper settings

See solder jumpers on how to change the solder jumper.

By changing the solder jumper SJ1, you can make connector SPI1 (nearest to the board edge) into the ICSP programming connector for the ATmegaxx8 on the board.

Protocol

For the intro to the SPI and I2C protocols read: SPI versus I2C protocols

The board specific protocol can be found here: DIO_protocol

You should also read the General_SPI_protocol notes.
For arduino, a sample PDE is available, called ardemo_lcd.pde, also at BitWizard software download directory .

This is a demo to send things using SPI to the lcd board. The SPI routines there are applicable for the DIO, 3FETS and 7FETS boards as well.

The software

Default operation

Future hardware enhancements

Future software enhancements

TODO: write a library to make handling this board easy.

Changelog

1.0

  • Initial public release